NAME

Device::Chip::PCF8574 - chip driver for a PCF8574

DESCRIPTION

This Device::Chip subclass provides specific communication to a NXP or Texas Instruments PCF8574 attached to a computer via an I²C adapter.

The reader is presumed to be familiar with the general operation of this chip; the documentation here will not attempt to explain or define chip-specific concepts or features, only the use of this module to access them.

MOUNT PARAMETERS

addr

The I²C address of the device. Can be specified in decimal, octal or hex with leading 0 or 0x prefixes.

METHODS

The following methods documented with a trailing call to ->get return Future instances.

write

$pcf->write( $val )->get

Sets the value of the GPIO pins, as an 8-bit integer.

Pins set low will sink current suitable for signalling or driving an LED. Pins set high will source current via a weak current-source to act as a pull-up for an active-low input signal, such as a button.

read

$val = $pcf->read->get

Reads the current logic levels on the GPIO pins, returned as an 8-bit integer. Pins of interest as inputs should have previously been set to high level using the "write" method.

as_adapter

$adapter = $pcf->as_adapter

Returns a new object implementing the Device::Chip::Adapter interface which allows access to the GPIO pins of the chip as if it was a GPIO protocol adapter. The returned instance supports the following methods:

$protocol = $adapter->make_protocol( 'GPIO' )

$protocol->list_gpios
$protocol->write_gpios
$protocol->read_gpios
$protocol->tris_gpios

AUTHOR

Paul Evans <leonerd@leonerd.org.uk>